You are here - All Product > Air Filters / Drain Valves > Oil Water Separator
Description
CS75 oil/water separator can be fitted on the same bracket as SEP 60 ST and can also be floor mounted.
Unlike SEP 60 ST, CS75 is not a disposable product and replacement filter cartridges can be purchased instead of replacing the whole product. 
CS75 has been carefully designed to clean condenstate from a compressor system of up to 75 cfm (2.1 m3/min) to as low as 5 ppm oil in water - suitable for discharge to sewer.
Can be wall or floor mounted and suitable for 11kW compressors.
10 year warranty.
Note: acceptable levels vary and it is the users responsibility to ensure compliance with local regulations
Important - always use automatic drains and set timed drains to very short open time. Use of manual drains could flood the CS75.
Mineral or blended synthetic oil & based on compressor oil carry-over of no more than 5 mg/m3
Technical Details
| 
										 Nominal Duty: 75 cfm (2.1 m3/min) @16 bar 
Service Life: Please see datasheet for information  Annual replacement is recommend. 
Connection: 
Inlet:  6mm push in 
Outlet:  10mm push in  | 
                                
                        Datasheets 
                                    1) CS75
                                 
                                
                                    2) CS75 Maintenance
                                 
                             |